WHERE TO USE

1) Interior floors, walls, countertops — do not use in critical water exposure areas

2) Concrete, masonry, plaster

3) Wallboard in dry areas only

4) Exterior grade plywood in dry interior areas

5) Existing ceramic tile

6) Resilient flooring

7) Existing plastic laminates

APPLICATION

1) Use a typical notched trowel (see chart) with sufficient depth to ensure proper transfer, covering at least 80% of the tile back.

2) Using the flat edge of the trowel, spread the adhesive on the substrate.

3) Apply additional material and comb the surface using the trowel’s notched side to achieve an even-setting bed.

4) Do not spread more adhesive than can be covered with tiles within 30 to 45 minutes.

     If skinning occurs, scrape off skin and replace with fresh adhesive.

5) Place tiles firmly in position on the fresh adhesive with a slight twisting motion to ensure a positive bond.

6) Make all alignments and adjustments immediately (do not exceed 45 minutes).

7) Promptly use water to clean smudges from the face of the tiles while adhesive is still fresh.

     Once adhesive has dried, clean with mineral spirits.

8.) Wash hands and tools with water while adhesive is still fresh.

9) Allow tiles to reach a firm set, then grout with an appropriate Gomix grout.