FEATURES AND BENEFITS
1) Water resistant
2) Excellent adhesion
3) Good flexural strength
4) Good impact resistance
5) Easy to use

AREA OF USE
1) PB02 Base Coat & Adhesive is used as an adhesive between mineral substrates and expanded polystyrene boards (EPS boards).

2) PB02 Base Coat & Adhesive is used as an embedding mortar applied over the EPS boards to embed the glass fiber mesh prior to
application of finish coats.

3) For interior and exterior use.

4) For all mineral and almost all organic substrates.

MIXING INSTRUCTION

1) Use clean equipment for mixing and preparation.

2) PB02 Base Coat & Adhesive powder : water = 4 : 1 parts by weight 25 kg powder : approx. 6.3 liter water

3) Add 6-7 quarts (5.7 – 6.7 L) of cool clean potable water.
4) Add PB02 Base Coat & Adhesive and mix to a homogenous consistency. It is mixed using a high speed drill.

5) Small amounts of clean potable water may be added to adjust workability.

6) Let the mixture stand for five minutes after initial mixing, then stir again, re-tempering once only as needed for workability.

7) PB02 Base Coat & Adhesive should be used immediately after tempering.

8.) Half batches may be mixed for convenience.

APPLICATION

Substrate:

1) The substrate must be firm, dry, clean and load bearing, frost-free as well as free of sinter layers, efflorescence and separating agents.
2) Critical substrates must be tested for suitability (create test surface).

3) If necessary, cleaning and/or priming of the substrate should be carried out.

4) Air and substrate temperature should not be less than + 5°C, not more than + 35 °C (until the material has completely set).

Adhesive:

1) Apply adhesive manually or by machine to the insulation board or to the wall.

2) Apply the PB02 Base Coat & Adhesive to the entire surface on one face of the insulation board, using a 5/8 in. (16mm) notched trowel for masonry and concrete or a 5/16 in. (8 mm) notched trowel for sheathing.

3) Adhesion share with adhesive application on the wall With EPS/XPS Boards min. 70 % of the board in adhered condition

4) The insulation boards must immediately be pressed into the fresh adhesive mortar bed, then floated in and pressed on.

5) The adhesion share with adhesive application onto the board minimum 60 % of the board in adhered condition.